Types of Belt Conveyor Drives:

Single Unsnubbed Bare / Lagged pulley Drive
Snubbed Bare / Lagged Pulley Drive
Tandem Drive
Special Drives

Single Unsnubbed Bare / Lagged Pulley Drive:

This is the simplest drive arrangement consisting of a steel pulley connected to a motor and the belt wrapped round it on an arc of 180°. This can be used for low capacity short center conveyors handling non-abrasive material. The pulley may be lagged to increase the coefficient of friction.

Snubbed Bare / Lagged Pulley Drive:

Here the angle of wrap is increased from 180° to 210° or even up to 230°, by providing a snub pulley to the driving pulley. In majority of medium to large capacity belt conveyors, handling mild abrasive to fairly abrasive materials, 210° snub pulley drive with load pulley lagged with hard rubber is adopted.

Tandem drive:

Here belt tension estimated to be high; the angle of wrap is increased by adopting tandem drives. Both of tandem pulleys are driven. The tandem drive with arc of contact from 300° to 480° or more can operate with one or two motors. The location of such drive is usually determined by the physical requirements of the plant and structural constraints.

Special Drive: